Posts by PR Office

We calibrate firmware for Harley Davidson motorcycles with Milwaukee 114-117 engines equipped with the Delphi MT21M ECU. We can tune virtually any parameter, including disabling catalytic converter monitoring and oxygen sensors for installing a custom exhaust system or in the event of sensor failure.

We perform firmware calibration for Yamaha F30 and F40 outboard motors with Kokusan Denki ECUs and M32R processors.

Stage 1 solutions have been tested for Arctic Cat M 1100 and Z1 series snowmobiles with 1056cc turbocharged engines equipped with Denso SH7052 ECUs.

Stage 1+ solutions with speed limit and rev limit removal for new CFMoto ATVs and buggies with Bosch MG1UA008 ECU have been rolled out.

The dynamic firmware Stage 1+ with the removed speed limit for Sharmax Force 420 Cyber (Forte 450) ATVs with Delphi MT05.3 ECU has been successfully rolled back.

Dynamic versions of Stage 1 firmware for Hongqi vehicles with 2.0L turbocharged engines with Bosch MG1US008 ECU have been successfully tested.

Stage 1 solutions have been tested for Polaris IQ 750 series snowmobiles with turbocharged 4-stroke engines equipped with Bosch M7.4.4 ECU.

We disable all ecology systems on specialized JCB equipment with the Delphi DCM3.3, DELPHI DCM7.24, and Bosch DCU17CV51 ECUs. We also perform proper urea disabling without warning messages on the dashboard. Engine eco-tuning is also available to increase torque and reduce fuel consumption.

ECUs have been successfully rolled out for Changan vehicles with 1.5L turbocharged engines equipped with Delphi MT95.1 ECUs.

Successfully rolled back Stage 1 firmware with removed speed limit and increased RPM cutoff for HND QRX650 series ATVs with electronic throttle and Bosch ME17.8.10 ECUs.