We offer proven Stage 1 tuning solutions for Voge motorcycles with 600cc and 800cc engines equipped with the Bosch MSE6.0 ECU. Our calibrations eliminate common factory issues associated with these models, such as surging and jerkiness in the mid-RPM range, throttle lag during rapid acceleration, and excessive mixture enrichment at high RPMs. Adjustments to the maximum RPM and top speed limits are also available.

We provide professional ECU remapping for Royal Enfield motorcycles equipped with the Continental M4C ECU. Stage 1 solutions have been validated for 650cc engines. Options include adjusting maximum RPM, fuel cut-off RPM, and top speed limits.

We have extensively tested all currently available firmware versions for Hisun Guardian 550 and 750 series ATVs equipped with electronic throttles and Bosch ME17.8.8 ECUs. Our firmware is the only one that eliminates factory issues such as jerky or abrupt throttle response, the inability to drive smoothly at low speeds in "H" (High) range, and an overly rich mixture during warm-up. Additionally, our firmware increases maximum power and torque and raises the RPM limiter to 8,500 rpm.

Stage 1+ tuning solutions have been tested for the Ford Mustang 6 facelift with a 5.0i V8 engine equipped with a Bosch MG1CS019 ECU. The resulting power output is 496 hp. Disabling the catalytic converter and secondary lambda sensors is also possible, as is adjusting the traction control.

The Stage 1 firmware for the new turbocharged CF Moto Zforce Z10 buggies with the MG1UA008 ECU has been successfully tested. Output power is approximately 200 hp. The redline has been shifted to 8600 rpm.

We provide professional firmware tuning for many Yamaha jet ski models equipped with Mitsubishi ECUs and MH8102F and MH8115F processors. We offer Stage 1 power boosts, maximum speed and RPM limiter removal, and more.

We calibrate Polaris motorcycle firmware with Bosch MS1.3 ECUs

We'll correctly disable all ecology systems for Ford and Lincoln vehicles with Continental 5WY8 ECUs. Stage 1 tuning is available for optimal engine performance and reduced fuel consumption.

We calibrate firmware for Harley Davidson motorcycles with Milwaukee 114-117 engines equipped with the Delphi MT21M ECU. We can tune virtually any parameter, including disabling catalytic converter monitoring and oxygen sensors for installing a custom exhaust system or in the event of sensor failure.

We perform firmware calibration for Yamaha F30 and F40 outboard motors with Kokusan Denki ECUs and M32R processors.